:: Upcycled Flower Power Rings :: Using Ring Pops + Mott’s Snack & Go Applesauce + Water Bottles ::

:: Upcycled Jewelry Projects ::

:: DIY Upcycling Projects ::
:: VERSION 1 ::

:: Here’s How You Do It ::

All you need is an upcycled ring from Ring Pops and the twist off cap from Mott’s Snack & Go Applesauce and some hot glue gun…of course!

It can’t get easier than this, truly! Twist off the Mott’s Snack & Go Applesauce cap and hot glue onto the upcycled ring from the Ring Pop. That’s it! So fun, so easy!

:: Upcycling Craft Projects :: Upcycled DIY Projects ::

:: VERSION 2 ::

But, just in case, you are up for the challenge…here’s a way to enhance your ring, and all you need is an upcycled water bottle ( look for one that has a good floral design on the bottom of the bottle). Here’s a comparison between both rings….you decide!

:: Upcycled Projects :: Upcycling DIY Projects ::

To make this type of ring (left), follow the steps above and then continue the steps below:

Cut the water bottle off leaving only the very bottom part.

Then make sure you cut around the edges in floral form and then in between the “petals”.

Use a wood burner and/or ice pick to make a hole in the center of the “flower petal”.

Then insert the “flower petal” into the ring of the Ring Pop as shown below:

Then glue the Mott’s Snack & Go Applesauce cap on top.

Now, you’ve got… FLOWER POWER!

:: Upcycling Projects :: Upcycled Craft Projects ::