:: Upcycled Jewelry Projects ::
:: DIY Upcycling Projects ::
:: VERSION 1 ::
:: Here’s How You Do It ::
It can’t get easier than this, truly! Twist off the Mott’s Snack & Go Applesauce cap and hot glue onto the upcycled ring from the Ring Pop. That’s it! So fun, so easy!
:: Upcycling Craft Projects :: Upcycled DIY Projects ::
:: VERSION 2 ::
But, just in case, you are up for the challenge…here’s a way to enhance your ring, and all you need is an upcycled water bottle ( look for one that has a good floral design on the bottom of the bottle). Here’s a comparison between both rings….you decide!
:: Upcycled Projects :: Upcycling DIY Projects ::
To make this type of ring (left), follow the steps above and then continue the steps below:
Cut the water bottle off leaving only the very bottom part.
Then make sure you cut around the edges in floral form and then in between the “petals”.
Use a wood burner and/or ice pick to make a hole in the center of the “flower petal”.
Then insert the “flower petal” into the ring of the Ring Pop as shown below:
Then glue the Mott’s Snack & Go Applesauce cap on top.
Now, you’ve got… FLOWER POWER!
:: Upcycling Projects :: Upcycled Craft Projects ::